A D V E R T I S E M E N T


Author Topic: Help getting PP Pizzone tiles to fit in flat  (Read 417 times)

0 Members and 1 Guest are viewing this topic.

Offline ajs123

  • Registered User
  • Posts: 12
  • Location: United States
  • I Love Pizza!
Help getting PP Pizzone tiles to fit in flat
« on: June 01, 2016, 08:48:29 PM »
Received my Pizzone today - only 6 days after ordering (eastern PA).

I'm unable to get the stock floor tiles to fit in flat. When pulled to the front underneath the lip on the back of the face, the rear portions of the two front tiles lift up off of the metal "rail" that runs down the center from front to back, so they sit 2-3 millimeters at least above the other tiles. Judging by how the rear tiles sit, with the gap between them not quite parallel (a subtle /\ where they meet), it appears that the center rail is lower than the two side rails.

Suggestions? I can try to get a good picture if that's not clear.

Thanks!
Alan

Offline parallei

  • Supporting Member
  • *
  • Posts: 1881
  • Location: Denver, CO

A D V E R T I S E M E N T