This is my first attempt at making a Pizza Hut pan pizza clone. I generally make New York-style pizzas but my family loves Pizza Hut. The recipe I used for this was the 22 ounce scaled version that Pete-zza calculated in another
thread. My directions are as follows:
The yeast was added to the water and allowed to activate and dissolve for 10 minutes. Next, I mixed in the salt, sugar, and dry non-fat milk. This combination was poured into a KitchenAid mixer followed by flour and vegetable oil. After a 10 minute kneed using the hook attachment, I let the dough rest, covered, inside the mixing bowl for 10 minutes before rolling it out into a 12-inch circle. The dough was then placed into a
Chicago Metallic Non Stick 14-Inch Deep Dish Pizza Pan (epicalien recommended this pan earlier in this thread) with 4 ounces of vegetable oil placed in the bottom. The top was covered using plastic wrap and the dough was proofed for 1 hour. Afterwards, I placed the dough into the refrigerator for approximately 12 hours. It was removed 2 hours before baking.
I preheated the oven to 500F with a FibraMent stone placed on the middle rack. Before topping, I slightly depressed the middle of the dough, leaving a 1 inch edge-crust. The pizza was topped with Jackie Tran's
sauce recipe, which was a near-perfect imitation of Pizza Hut's. I used 2 cups of low moisture part skim mozzarella (though I saw an ex-Pizza Hut employee say that they used 3 cups on their large pan pizzas, 4.5 if it's a cheese pizza). Half of the cheese was put on top of the sauce, followed by diced onions and green peppers, then the other half of the cheese. I finished topping it with pepperonis. Before going into the oven, I sprayed the edge crust with a vegetable oil cooking spray. The pizza was baked for 12 minutes on the stone.
The pizza turned out great and it will be a recipe that I try again in the future. Thanks to everyone who put in effort on cloning this!